Manuál Philips QC5135 Zastřihávač vlasů

Manuál

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benet from the support that Philips offers,

register your product at www.philips.com/welcome.

General description (Fig. 1)

A Hair clipping comb

B Length setting selector

C Cutting element

D On/off slide

E CHARGE light

F Socket for appliance plug

G Adapter

H Appliance plug

I Cleaning brush

J Beard trimming comb

Important

Read this user manual carefully before you use the

appliance and save it for future reference.

Danger

- Make sure the adapter does not get wet.

Warning

- Check if the voltage indicated on the adapter and on

the appliance corresponds to the local mains voltage

before you connect the appliance.

- The adapter contains a transformer. Do not cut

off the adapter to replace it with another plug, as

this causes a hazardous situation.

- This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a

person responsible for their safety.

- Children should be supervised to ensure that they

do not play with the appliance.

Caution

- Never immerse the appliance nor rinse it under the

tap.

- Do not use the appliance in the bath or in the

shower.

- Use, charge and store the appliance at a temperature

between 15°C and 35°C.

- Only use the adapter supplied to charge the

appliance.

- If the adapter is damaged, always have it replaced

with one of the original type in order to avoid a

hazard.

- Do not use the appliance if the cutting element, the

hair clipping comb or the beard trimming comb is

damaged or broken, as this may cause injury.

- This appliance is only intended for clipping human

scalp hair and facial hair. Do not use it for any other

purpose.

Compliance with standards

This Philips appliance complies with all standards

regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this user

manual, the appliance is safe to use based on scientic

evidence available today.

Charging

Do not charge the appliance for more than 24 hours.

Charging takes approx. 10 hours.

When the appliance is fully charged, it has an operating

time of 40 minutes.

1 Make sure the appliance is switched off.

2 Insert the appliance plug into the appliance (Fig. 2).

3 Put the adapter in the wall socket.

, The CHARGE light goes on to indicate that the

appliance is charging.

Note: The CHARGE light does not indicate when the

appliance is fully charged.

Optimising the lifetime of the rechargeable

batteries

Discharge the rechargeable batteries completely twice

a year by letting the motor run until it stops. Then fully

recharge the batteries.

Corded clipping

If the batteries are low, you can also use the

appliance from the mains.

Only use the appliance from the mains when the

rechargeable batteries are almost empty.

1 Switch off the appliance.

2 Connect the appliance to the mains and wait a few

seconds before you switch it on.

If the rechargeable batteries are completely empty, wait a

few minutes before you switch on the appliance.

Using the appliance

Clipping with hair clipping comb

Note: Make sure your hair is clean and dry. Do not use the

appliance on freshly washed hair.

1 Comb your hair with a styling comb in the

direction of hair growth. (Fig. 3)

2 Slide the hair clipping comb into the guiding

grooves of the appliance (‘click’) (Fig. 4).

Make sure that the arms of the comb have been properly

slid into the grooves on both sides.

3 Press the length setting selector (1) and then move

the hair clipping comb up or down (2) to set the

desired length setting (Fig. 5).

, The corresponding hair length is visible on the side

of the comb.

Length settings

With the hair clipping comb attached, the appliance can

cut hair to 10 different lengths:

Hair lengths in mm Hair lengths in inches

3 1/8

5 3/16

7 9/32

9 3/8

11 7/16

13 1/2

15 5/8

17 21/32

19 3/4

21 7/8

4 Slide the on/off slide upwards to switch on the

appliance (Fig. 6).

5 Place the hair clipping comb on the scalp and move

the appliance through the hair slowly.

Tips

- Start clipping at the highest length setting of the

hair clipping comb and reduce the length setting

gradually.

- Write down the length settings you have used to

create a certain hairstyle as a reminder for future

clipping sessions.

- To clip in the most effective way, move the appliance

against the direction of hair growth.

- Since hair grows in different directions, you need

to move the appliance in different directions as well

(upward, downward or across) (Fig. 7).

- Make overlapping passes over the head to ensure

that the appliance catches all the hairs that need to

be cut.

- Make sure that the at part of the hair clipping comb

is fully in contact with the scalp to obtain an even

clipping result.

- To achieve a good result with curly, sparse or long

hair, you can use a styling comb to guide the hair

towards the appliance.

- Regularly remove cut hair from the hair clipping

comb. If a lot of hair has accumulated in the comb,

remove it from the appliance and blow and/or shake

the hair out of it.

Clipping without hair clipping comb

You can use the appliance without hair clipping comb to

clip your hair very close to the skin, to a length of 1mm

(1/32 in) to contour the neckline and the area around

the ears.

1 To remove the hair clipping comb, press the length

setting selector (1), move the comb upwards and

then pull it off the appliance (2). (Fig. 8)

2 Comb the hair ends over the ears before you start

to contour the hairline.

3 Slide the on/off slide upwards to switch on the

appliance (Fig. 6).

4 Tilt the appliance in such a way that only one

edge of the cutting element touches the hair

ends. (Fig. 9)

5 Only cut the hair ends. The hairline has to be close

to the ear.

6 To contour the neckline and the sideburns, turn the

appliance and make downward strokes (Fig. 10).

7 Move the appliance slowly and smoothly. Follow the

natural hairline.

Trimming with beard trimming comb

Note: Make sure your facial hair is clean and dry.

1 Combyourbeardormoustachewithanecomb

before you start trimming.

2 Slide the beard trimming comb into the guiding

grooves of the appliance (‘click’) (Fig. 11).

Make sure that the arms of the comb have been properly

slid into the grooves on both sides.

3 Press the length setting selector (1) and then move

the beard trimming comb up or down (2) to set

the desired length setting (Fig. 12).

Length settings

With the beard trimming comb attached, the appliance

can cut hair to 8 different lengths:

Hair lengths in mm Hair lengths in inches

1.5 1/16

3.5 1/8

5.5 7/32

7.5 9/32

9.5 3/8

11.5 7/16

13.5 17/32

15.5 5/8

4 Slide the on/off slide upwards to switch on the

appliance (Fig. 6).

5 Place the beard trimming comb on the face and

move the appliance through the hair slowly (Fig. 13).

Tips

- When you trim your beard for the rst time, start at

a length setting that is higher than the length of your

beard hairs and reduce the length setting gradually.

- To trim in the most effective way, move the appliance

against the direction of hair growth.

- Make overlapping passes over the chin to ensure

that the appliance catches all the hairs that need to

be cut.

- Make sure that the at part of the beard trimming

comb is fully in contact with the face to obtain an

even trimming result.

- Regularly remove cut hair from the beard trimming

comb. If a lot of hair has accumulated in the comb,

remove it from the appliance and blow and/or shake

the hair out of it.

Creating a stubble beard

- To create a stubble beard, trim with the beard

trimming comb set to 1.5mm (1/16in).

ENGLISH

2

4222.002.8140.1

Hodnocení

Více o tomto návodu

Chápeme, že je hezké mít k vašemu Philips QC5135 Zastřihávač vlasů papírovou příručku. Manuál si můžete vždy stáhnout z našich webových stránek a vytisknout si jej sami. Pokud byste chtěli mít originální příručku, doporučujeme vám kontaktovat Philips. Možná by byli schopni poskytnout originální návod. Hledáte příručku ke svému Philips QC5135 Zastřihávač vlasů v jiném jazyce? Vyberte si preferovaný jazyk na naší domovské stránce a vyhledejte číslo modelu, abyste zjistili, zda jej máme k dispozici.

Specifikace

Všechny návody pro Philips Zastřihávače vlasů
Další manuály Zastřihávače vlasů

Často kladené otázky o Philips QC5135 Zastřihávač vlasů

Náš tým podpory vyhledává užitečné produktové informace a odpovídá na často kladené otázky. Pokud v nich najdete nějakou nepřesnost, kontaktujte nás prostřednictvím našeho kontaktního formuláře.

Související produkty

Manuál

Philips HC5630 Zastřihávač vlasů

Manuál

Philips QC5510 Zastřihávač vlasů

Manuál

Philips HC7460 Zastřihávač vlasů

Manuál

Philips QG3391 Zastřihávač vlasů

Manuál

Philips QG3060 Zastřihávač vlasů

Manuál

Philips HC5612 Zastřihávač vlasů

Manuál

Philips QC5130 Zastřihávač vlasů

Manuál

Philips QG3030 Zastřihávač vlasů

Související kategorie