Manuál Bionaire BASF40LM Větrák

Manuál

3. Using a cross head screw driver, remove the

screws (U) from the neck joint (T) of the

motor housing assembly. Slide the neck joint

(T) into the upper extension pole (H). Align

the screw holes of the neck joint (T) with the

screw holes of the upper extension pole (H)

and secure with the two screws (U) that you

removed at the beginning of this step. Refer

to Figure 3.

4. Remove the rear grill lock (P) from the motor

housing assembly (F). Refer to Figure 4.

5. Secure the rear grill (E) to the motor housing

(F) using the rear grill lock (P). Tighten the

rear grill lock (P) until the rear grill (E) is

secured to the motor housing (F). Refer to

figures 5 and 6 for the proper alignment of

the rear grill (E) to the motor housing (F).

6. Secure the fan blade (C) to the motor shaft

by tightening the locking screw (D) into the

notch (Q) on the motor shaft. Refer to figure

7 for correct alignment of the fan blade (C)

and locking screw (D) to the shaft.

7. Snap the front grill (A) into the grill ring (B).

Make sure the logo is properly aligned.

Please note that you may need to unscrew

the grill ring screw (O) with a cross head

screw driver in order to place the front grill

(A) into the grill ring (B). Refer to Figure 8.

OPERATING INSTRUCTIONS

Speed Control (R) =

0 - Off

I - Low

II - Med

III - High

ADJUSTMENT INSTRUCTIONS

Tilt Adjustment

Loosen Tilt-Adjustment Knob (G), move fan

head to desired angle, and tighten Tilt

Adjustment Knob (G) to lock in place.

Height Adjustment

Loosen height adjustment knob (I), adjust upper

extension pole (H) to desired height and tighten

height adjustment knob (I) to lock in place.

Oscillation Adjustment

Press, Pull Oscillation (S) = start, stop.

CLEANING AND MAINTENANCE

• Always unplug the fan before cleaning.

• Do not allow water to drip on or into the fan

motor housing.

FITTING A REPLACEMENT PLUG

FOR U.K. AND IRELAND ONLY

If the plug is not suitable for the socket outlets in

your home, it can be removed and replaced by a

plug of the correct type. Please refer to

"Installation of a plug" below.

Installation of a plug Applicable to U.K.

and Ireland.

WARNING - THIS APPLIANCE MUST BE

EARTHED.

NOTE: If the terminals in the plug are not marked

or if you are unsure or in doubt about the installation

of the plug please contact a qualified electrician.

The wires in the mains lead are coloured as such:

GREEN AND YELLOW - EARTH

BROWN - LIVE

BLUE - NEUTRAL

Please note that the colour of these mains wires

may not correspond with the colour markings

that identify the terminals in your plug.

Please proceed as follows:

The wire which is coloured GREEN AND YELLOW

must be connected to the terminal which is marked

with the letter 'E' or by the earth symbol or

coloured GREEN AND YELLOW.

The BROWN coloured wire must be connected

to the terminal, which is marked with the letter

"L" or is coloured RED.

The BLUE coloured wire must be connected to

the terminal, which is marked with the letter "N"

or is coloured BLACK.

If a 13A 3-pin plug is fitted, it must be an ASTA

approved plug, conforming to BS1363 standard.

Replacement 3A fuses must be BSI or ASTA

BS1362 approved.

GUARANTEE

PLEASE KEEP YOUR RECEIPT AS THIS

WILL BE REQUIRED FOR ANY CLAIMS

UNDER THIS GUARANTEE.

• This appliance is guaranteed for 2 years after

your purchase as described in this document.

• During this guaranteed period , if in the

unlikely event the appliance no longer

functions due to a design or manufacturing

fault, please take it back to the place of

purchase, with your till receipt and a copy of

this guarantee.

• The rights and benefits under this guarantee

are additional to your statutory rights which

are not affected by this guarantee. Only

Holmes Products (Europe) Ltd. (“Holmes”)

has the right to change these terms.

3 amp

3

PLEASE READ AND SAVE THESE

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic safety

precautions should always be taken including

the following:

• Use the fan only for purposes described in

the instruction manual.

• To protect against electrical shock, do not

immerse the fan, plug or mains cable in

water or spray with liquids.

• Close supervision is necessary when any

appliance is used by or near children.

• Unplug from the electrical outlet when not in

use, when moving the fan from one location

to another, before putting on or taking off

parts and before cleaning.

• Avoid contact with any moving parts.

• Do not operate in the presence of explosives

and/or flammable fumes.

• Do not place the fan or any parts near

an open flame, cooking or other heating

appliance.

• Do not operate any appliance with a

damaged mains cable, plug, after the

appliance malfunctions, or has been

dropped/damaged in any manner.

• The use of attachments not recommended or

sold by the appliance manufacturer may

cause hazards.

• Do not let the mains cable hang over the

edge of a table or counter, or come into

contact with hot surfaces.

• To disconnect from the electrical supply, grip

the plug and pull from the wall outlet. DO

NOT pull on the mains cable.

• Always use on a dry, level surface.

• Do not operate without the fan grills

properly in place.

• This product is intended for household

use ONLY and not for commercial or

industrial applications.

• Should the appliance stop working, first

check the fuse in the plug (UK only) or

fuse/circuit breaker at the distribution board is

operating, before contacting the manufacturer

or service agent.

• If the supply cord or plug is damaged, it must

be replaced by the manufacturer or its

service agent or a similarly qualified person

in order to avoid hazard.

• The appliance contains no user serviceable

parts and should the product suffer damage

or breakdown it must be returned to the

manufacturer or its service agent.

• Do not use outdoors.

• The fan should not be operated without its

base fitted.

• The fan should not be operated laying on its side.

• NOTE: Use caution when adjusting the tilt

angle of the fan head to ensure that your

fingers do not get caught.

• This appliance is not intended for use by

persons (including children) with reduced

physical, sensory or mental capabilities, or

lack of experience and knowledge, unless

they have been given supervision or

instruction concerning use of the appliance

by a person responsible for their safety.

Children should be supervised to ensure

that they do not play with the appliance

DESCRIPTIONS (See Fig. 1-8)

A. Front Grill

B. Grill Ring

C. Fan Blade

D. Locking Screw

E. Rear Grill

F. Motor Housing Assembly

G. Tilt-Adjustment Knob

H. Upper Extension Pole

I. Height Adjustment Knob

J. Lower Extension Pole

K. Base Cover

L. Base Weight

M. Weight Cover

N. L-Shaped Wrench Screw

O. Grill Ring Screw

P. Rear Grill Lock

Q. Notch on Motor Shaft

R. Speed Control Knob

S. Oscillation Control Knob

T. Neck Joint

U. Securing Screws (2)

MISSING A PART FOR YOUR FAN?

Please call 0800 052 3615 for assistance.

ASSEMBLY INSTRUCTIONS

Please see pictures on inside cover

pages (Fig. 1 - 8)

Assembly Time: 10-15 Minutes.

Tools Required: Cross Head Screw Driver.

1. Carefully remove all parts and make sure that

they are all present. Refer to Figure 1.

2. Secure the lower extension pole (J) to

base cover (K) and base weight (L) using

the wrench screw (N) and weight cover

(M). Refer to Figure 2.

ENGLISH

2

Hodnocení

Více o tomto návodu

Chápeme, že je hezké mít k vašemu Bionaire BASF40LM Větrák papírovou příručku. Manuál si můžete vždy stáhnout z našich webových stránek a vytisknout si jej sami. Pokud byste chtěli mít originální příručku, doporučujeme vám kontaktovat Bionaire. Možná by byli schopni poskytnout originální návod. Hledáte příručku ke svému Bionaire BASF40LM Větrák v jiném jazyce? Vyberte si preferovaný jazyk na naší domovské stránce a vyhledejte číslo modelu, abyste zjistili, zda jej máme k dispozici.

Specifikace

Všechny návody pro Bionaire Větráky
Další manuály Větráky

Často kladené otázky o Bionaire BASF40LM Větrák

Náš tým podpory vyhledává užitečné produktové informace a odpovídá na často kladené otázky. Pokud v nich najdete nějakou nepřesnost, kontaktujte nás prostřednictvím našeho kontaktního formuláře.

Související produkty

Manuál

Bionaire BAOF30B Větrák

Manuál

Bionaire BAOF30M Větrák

Manuál

Bionaire BASF40W Větrák

Manuál

Bionaire BASF40B Větrák

Manuál

Bionaire BAC14 Větrák

Manuál

Bionaire BT14 Větrák

Manuál

Bionaire BASF 1016 G Větrák

Manuál

Bionaire BT18 Větrák

Související kategorie