4
9. Do not press the device into the fabric as this may damage the fabric.
10. Do not use the device on clothes you are wearing, always take them off. This may
cause personal injury or damage to the lint remover.
13. Do not use the device on silk, wool, or linen garments. This can damage fabrics and
damage the shaver blades.
12. Take care not to use the device on buttons, zips, appliqués, patches, stickers, labels,
rips, seams, and seams.
11. The device has a protective lock. It will not function unless the blade cover is refitted.
Device description:
1. Battery level indicator 2. Battery charging indicator
5. USB type C charging port 6. Blade Cover
7. Blades 8. Rotary shaft
9. Bin for knots and pilling 10. Housing
11. Cleaning brush 12. USB charging cable
16. Do not handle the device with wet hands.
3. Working speed indicator 4. Button for changing the working speed / ON OFF power
14. Do not use the device near water, e.g. in the shower, bathtub, or over a wash basin
with water.
15. Do not allow the device to get wet. Before using the appliance again, it must be
checked by a qualified electrician.
17. The device should be turned off each time it is put away.
USING THE DEVICE
The device should not be used while charging.
2. Switch on the device by pressing the button (4), the device has three speeds. To increase the speed, press button (4) again. Available
speeds: 6500, 7500, 8500 rpm
1. Place the garment (fabric) on a flat surface, and smooth out the wrinkles.
4. Stubborn knots can be removed by moving the device across and then along ("checkered") on one small piece of clothing.
6. For fabrics with a pattern, move the device in the direction of the pattern.
2. Unscrew the blade protection cover (6) counter clockwise.
7. The lint roller and cleaning brush are located in the holder, to remove them follow the Fig. 1, on page 2
4. Clean the blade cover (6), the blades (7), and the rotating shaft (8) with the included brush (11).
3. Remove the blades (7) by pulling them upwards (Caution! The blades are very sharp!).
6. After cleaning, reassemble all the disassembled parts.
Power supply: USB 5V/1A
1. Switch off the device by pressing the button (4).
To start charging, plug the charging cable (12) into the charging socket (5) and then connect it to the power supply.
When the battery is fully charged, the battery level indicator will show 100%. The time to fully charge the battery is 2-3 hours. When fully
charged, the run time is approximately 120 minutes, depending on the selected speed.
When connected to power, the battery charge indicator (2) will illuminate and the battery charge indicator (1) will display the current
battery charge.
3. Move the device back and forth across the material.
5. Thin garments can be defrosted by placing them on flat, rigid cardboard.
5. Empty the knots and lint container (9).
CLEANING
BATTERY CHARGING:
TECHNICAL DATA:
The device has a protective lock. It will not function unless the blade cover (6) is refitted.
Power Nom.: 5W, Power Max.: 10W
13. Lint roller 14. Bottom cover
Zapojte se do konverzace o tomto výrobku
Zde můžete sdílet, co si myslíte o Adler AD 9619 Odstraňovač žmolků. Máte-li dotaz, nejprve si pozorně přečtěte návod. Žádost o příručku lze provést pomocí našeho kontaktního formuláře.